Trail Tech Voltage Regulator Wiring Diagram. Stator must have a floated ground Wire connection for use with most machines. I've been blowing taillights but also brake.
Puch uses separate coils/ wires for taillight, Headlight and brakelight. The BAT post has a yellow wire leading to it from the starter solenoid. The magnitude of the voltage produced by these generators depends upon the RPM of the engine.
Linear voltage regulators are power inefficient as they dissipate lots of power in the form of heat.
Trail Tech's Regulator/Rectifier will not work with most factory stators.
Definition: The induction voltage regulator is a type of an electrical machine in which the output voltage may be varied from zero to a certain maximum value depending upon the ratio of turns in The schematic diagram of the single phase induction voltage regulator is shown in the figure below. I'm trying to test the voltage regulator as the charging system doesn't seem to be working. Understanding wiring of motorcycle voltage regulators.